VAG ECU TOOL - EDC15 and ME7 eeprom read & write access

The tool for the complete access to all EEpromdaten with VAG-engine control units of type EDC15 and ME7.

1.                  Read and write access to the EEprom.

2.                  Reading the secret odometer (if stored in the engine control unit)

3.           Immo-off function, login display, VIN change - everything about the diagnosis socket - not removing the ECU.

4.                  With the write function is motor control "cloning" - no need to teach.

5.                  Indispensable for workshops, recovery or Chiptuning.

Functions of the program:

1.     serial EEprom read and save

2.     EEprom checksum checking and correction

3.     IMMO on / off

4.     EEprom from a file and write (clone function)

5.     Read / write access to the login

6.     Read / write access to the chassis number

7.     Read / write access to the Immobilizernummer

8.     Kilometers Motronic in the read and write (if available)  

In the ME7 .** controllers can also perform the following functions:

·   Offset channels

·   Mixture enrichment

·   Idling torque change

·   Lambda value

·   Idle speed change

·   Correct charge (only for Turbo engines)

·   Ignition timing change

Supports the following types of motor control of BOSCH:

1.                  EDC15

2.                  EDC15VM

3.                  EDC15P

4.                  EDC15P +BOSCH ME7.5

5.                  BOSCH ME7.5.1

6.                  BOSCH ME7.1

7.                  BOSCH ME7.1.1