H type Automatic transfer switch(ATS)

Automatic Transfer Switch ( ATS ) specification

1) YES1-100HB: 3P, 4P, 16-100A
2) YES1-160HB: 3P, 4P, 100-160
3) YES1-250HB: 3P, 4P, 200-250A
4) YES1-400HB: 3P, 4P, 400A
5) YES1-630HB: 3P, 4P, 630A
It has a logic control board,different logic commands to control the operation of
the gear-motor directly assembled in the switch to ensure the position of the switch. The gear motor is made of neoprene to insulate wetness and heat, has a safety device. It will trip off when the temperature is over 110°C and when it is under over current status, when the trouble is disappear, then device will automaticallu resumes its work, the reversible reduction gear adopts straight tooth gear.
About the operation:when the key is under automatic starts,this kind ATS will self-input
and self-recovering ,once the hand is emergency operation, It'll return back after
delay time about 60s Through terminal is 102.103 to force remote control turn
to"0" Position.optimum selection of switches 202.204. Emergency manual operation, to
use the hand turn the 90° at each position.

REGULATE INSTRUCTION
When use operating handle, operated switch on/off three times, it should be operated
neatly. Full-automatic regulation: discharge handle, connect with relative line,
start electric lock, turn on common and reserve power, the switch should transfer
to "I" position, then cut off common power, the switch should transfer to "II"
position; turn on common power again, the switch should transfer to "I" position
back.

Compulsory "0" regulation: When common power working, start compulsory "0" self-lock button, the switch should transfer to "0" position; when reserve power working,
start compulsory "0" self-lock button, the switch should transfer to "0" position.

Long range control regulation: When common power working, start "II" button, the
switch should transfer to "II" position; when reserve power working, start "I" button,
the switch should transfer to "I" position;
Exam signal indicator light: When common/reserve power is on/off, switch "I/II"
making and breaking, electric/mechanic padlock is on/off, any signal indicator light
should indicate relatively.
After regulation, close down the power first, transfer switch to position "0" with
handle.
After install, discharge electric key and operating handle and keep respectively
preventing accident.