Description:1)Alarm mode: Give an alarm warnning while Alarm density reaches: Coal gas: 1000~5000ppm, LGP: 1000~5000ppm, natural gas: 1000ppm~5000ppm 2)Working mode: indepedent & compatible mode: work solely at party,room etc. work with our burglar alarm panel,so the alarm panel automatically dial up the alarm phone. 3) siren:>90db 4) strict method with good quality SPECIFICATION:1. Operating Voltage:AC220V, or AC110V; DC12~20V2. Working temperature: -10degree~50 degree 3. Alarm density: Coal gas: 2000ppm+/- 30%, natural gas: 2000ppm+/-30%,Liquid petroleum gas: 5000ppm+/-30%,5. Operating Frequency: 433 MHZ/315MHZ (optional)4. Responding time: less than 2 seconds 6. Net Weight: 0.2kg 7.Size: 115mm(L)*71mm(W)*43mm(H)
1. Description:Pet immune PIR motion detector is designed with high technology. It features high anti-magnetism, anti-light, Pet friendly, induction direction identified, low power alert, temper switch,auto-temperature compensation and lowest power consumption. Widely used for window, veranda, aisle and so on.2. Specification1) Sensor: Dual passive infrared (imported), lowest noise.2) Pet immune: about 15kg.3) Voltage: DC3V Current: 40uA (stand by)4) Output time: 2second 5) Alert time between two alert: 6 second6) Low batter indicator: Led flash one time per 5 second7) Detected range: 110°*9m(max when setting for induction direction identified) 110°*12m(max without induction direction identified ) 8) Frequency: 433/315MHZ(optional)9) Transmitter distance:>180m (open area) 10) Size:110×70×40mm11) Temperature: 20～55℃12) Humidity: 10～`93％3. Installation1). Coding address: preset by manufacture or by user. If not , please refer to code diagram to set it.Install the detector to the proper place where intruder must enter.Do not face the detector to any area where window, lamp-house,heat thing and so on.It is used for indoor,not for outdoor.Installing height suggested: 1.5~2.5 m 2).When power is on, LED flashed , it is initialized time, please do not walk in its detected range. After flashed again in a few seconds. It starts to normal work.3).LEDFlashed three times：send alert Flashed five times：detected somebody from inside going outside, it will not send alert.4).Operation settingA jumper: LED output optional, no jumper,no output, with jumper output indicatorJP3: F jumper: with jumper to have maximum distance. M jumper: with jumper to have normal medium distance (default)N : F M N : no jumper to have nearest distance.5).Walk testNormal test: when the detector enters into working mode after three minute, walk for ten times to test it. Test in two times must be over seven seconds. Ensure each time has affective alert. O r, you should change the angle to fit the demand.NOTE: in more far range, it is normal for the detector to delay to send alert.4. Caution: . When installing, do not drop down or hit the detector so to avoid the internal infrared sensor.Do not touch the sensor lens so to avoid the detecting distance and sensitivity.Choose proper returning time to avoid alert.Have termly walk test
Main FeaturesLarge Graphic LCD, LCD Backlight Excellent Voice Quality CDMA 2000 1x Data Service up to 153.6 Kbps. Sending/Receiving SMS Available for RUIM The Most Advanced Module of CDMA,Easy to Operate Signal Strength,Voice Mail,Battery Strength,Realtime Clock Indicators 30 Records for Outgoing,Incoming and Missed Calls Support Call Forward, Call Waiting,Call Trasfer,3 Way Calling Keyboard Lock,Alarm Clock,Schedule SpecificationsWorking Frequency Range: CDMA 800MHZ 2000 1x RTT Tx Frequency: 824.640-848.370MHZ Rx Frequency: 869.640-893.370MHZ Max. Output Power : Working Voltage : DC +5V Idle current working current: 200~350mA RX Sensitivity : -104dBm Operating Temp. : -2 ° C ~ +55° C Storage Temp. : -30° C ~ 60° C Humidity : 0 ~ 95% Battery: Lithium Ion, 3.7~4.2VDC Min. Standby Time: >24 Hours NET/Gross Weight: 700g/960g Size: 250×215×92mm AC Adapter Input: AC 110-240V 50-60HZ AC Adapter Output: DC +5V Antenna Type: BNC,TNC
Browse internet with high speedFile TransmissionVoice callingReceive/Send E-mailReceive and Send Short Message (SMS)Specifications:Frequency band :824Mhz-849Mhz 869Mhz-894Mhz(Uplink and Downlink)Wireless Network:CDMA 2000 1x compatible with IS-95 A/BOperating System: Windows 2K XP Vista Uplink and downlink transmit speed : 153.6kbpsInterface: USB2.0/Express card 34 / Express card 54Power Supply: USB / Express cardWeight: 42g(Approx)With one year warranty
ATS998 Wireless 2 Way Intercom DECT telephone DECT Phone (Digital Enhanced Cordless Telecommunications)Doorbell IntercomWireless Control the UnlockThe Doorbell Intercom Chime Kit allows you to speak to your caller before you open your door. The outdoor unit is weatherproof (IP44 rated) and can be powered either by batteries or by a separate transformer (not included).The indoor receiver not only works as an intercom, but can also be used as a normal DECT phone as well, with an operating distance (free range) of 100 meters. The transformer and telephone cable are included in this kit.
Description:*8 wired guard areas, 8 wireless guard area, each guard area could single do procedure. *Quickly number communicate way, use Ademco4+2 communication agreement to transfer the signal to the alarm center.*There could be 4 groups of police calling number, one group of center police calling number, recycling call. *5 guarding ways: left guarding, perimeter guarding, single guarding area guarding, delay guarding and remote guarding.*5 kinds of guarding: instant guarding area, delay guarding area, 24 hours of guarding area,perimeter guarding area and side guarding area*4 kinds of off guarding way: code keyboard off guarding, wireless remote control off guarding, remote off guarding and accept call off guarding*3 kinds of controlling way: keyboard, remote control and remote call*Receiving call center, telephone and local alarm to recycle alarming*inside monitor to remote knowing the scene situation*inside voice module, could record invoice for nearly 20 seconds for voice-alarm*use remote controller to set guard, off guard and urgent alarm*4 numbers of user code are used for protecting the system security, it could be modified by user.*it could dials 4 sets of telephone number and one set of center number*recorder, monitor, remote control, guard area control, telephone line checking and its relative parameter, they could be set by the system keyboard*it can use the main sets keyboard to operate, simper and easy.*wired guard area could be open or close, easy to install*LED light direction*has the guard dog function, can void shutdown*accept CPU tiny dispose, SMT manufacture to be a stable capability
Description:Loud 85 decible alarm Permanent carbon monoxide sensor. Powered by one 9 V battery ( size: 6F 22 or Alkaline 6LR61). The alarm sound pattern is pulsed the alarm beeps. This continues until the CO eliminated. The red LED will flash once every one second while in alarm mode. One Chirp every 40 seconds in an indication that the batteryis Low ( need replacement) Test button to teat the units electronics and verifies proper unit operation Red LED light flashing once every 40 seconds to indicate normal operation mode. The Carbon Monoxide (CO) alarm monitors the air for the presence of CO. The alarm will sound and be accompanied by the flashing red LED light when there are highlevels of CO. present. Caution: This alarm will only indicate the presence monoxide gas may be prestn in other areas, Carbon monoxide gas may present at other area. SPECIFICAITON:Power supply: 9 V Alkaline battery 6LR61Sensitivity Setting: 150+/-50ppm CO concentrationStandby Current: Alarm Current:Operation Ambient condition: 4~38 °C, 25~85% R.H
Description:This personal anti-losing alarm adapts macro-computer control technology with multi-coding. It protects valuable articles (or human being ) and anti-theft by compounding ofreceiver and transmitter. It becomes your first choosing for anti-losing. So convenient, Itis used for mobile, wallet, luggage, package,childen,key and so on . Good looking andgreen environment protection. Specificaiton:receive and transmitter alarm triggered distance :1-25m adjustedanti-lost, searching function, alarm with vibrating convenient use, easy operation, small size, and portable. PACKAGE:Transmitter: 44 (H) ×28 (W) ×8 (D) mm. Weight: 9.3 g. Battery: CR 2032 ×1 (3V)Receiver: 460 (H) ×36 (W) ×15 (D) mm. Weight: 35.5 g. Battery: NO. 7 ×1(1.5V, AAA size)
FUNCTIONRotation controlSupport UPNP,easy-to-useTrends domain name solutionIE browseTrends assign IP addressWire and wireless network interfaceSpecificationImage: JPEGSensor: CMOS,1/4”Image solution:VGA（640x480）/ QVGA（320x240）Wireless network interface: 802.11b/gWork frequency: 2400-2483.5MHz or 2400-2483.5MHzNetwork max transport speed: 30f/s（QVGA）, 15f/s（VGA）Newwork protocol: TCP/IP，DHCP，SMPT，HTTP，DDNS，UPNP，PPPoEAlarm control: output：1（5VDC，0.1A）；input：1 （trigged by closed circuit）Rotation control: h120°;v90°Motion detect: supportSoftware updated: automaticalControl mode： IE or professional programReplay : by media softwareSecurity: password entry.Minimum illuminance solution: 2.0Lux@550nmBalance： supportLens: CSWorking condiction: 0 - 50C°，20% - 80%PHOutput adaptor: （PS-D）：220VAC/5VDC，1APower: 3WSize：110mm*110mm*100mm（without antenna）Gross Weight：0.8Kg
Product OverviewGSM-MGPS MICRO COMPUTER CAR ALARM SYSTEM is a new version of two-way car alarm system. It combines the GSM mobile communication, MGPS locating technology andMICROCHIP rolling code technology, multi-code mating and microcomputer technology.The car owners can remote control the car by telephone in another place even inanother city. This system can call any telephone number automatically upon there is alarin the car.It can also arm, disarm, speak to the car, and cut off the electricity or petrolic circuit,remote start, and monitor. If the car is lost or robbed, this system can locate the car.Function Alarm and Trigger ModeShock AlarmPower Off and Wire Cut-off Alarm: Alarm Memory RecallParking Warning Instantaneous Trigger Report Auto FunctionResume the Armed Condition upon Door not OpenedWarning of Disarm with Door ClosedWarning of Door Opened with Car ArmedResume the Armed Condition upon Power on Automatic Central LockElectric/Air Compressor Lock OptionalRemote ControlTelephone Operation:Arm/Disarm;Prohibit or Permit Telephone AlarmProhibit Telephone AlarmPermit Telephone AlarmClose /Open Vibrator by Telephone Monitor by Telephone Speak to the Car by TelephoneStop the Engine by TelephoneLock/Unlock the Door by TelephoneInquire by TelephoneBasic Components1 mainframe, 2 remote controls, 1 dialer, 1 vibrator, 1 siren, 1 relay, 1 emergency help switch, 1 LED, 1 microphone, 1 bundle of output wire (12 holes), 1 bundle of input wire (8 holes), 1 bundle of input wire (4 holes), 1 bundle of start connection wire, 1 operatinginstruction, 1 bundle of fastening wireTechnical Specification1. Mainframe Working Voltage: 12V Static Current (+GSM Module): 40mA -60 mA Arm/Disarm Working Frequency: 315MHZ-316HMZ Cover Area and Capacity: identical to the GSM system Location Accuracy: 10-300M (which depends on the GSM service) Alarming Time: Last until it is disarmed or the alarm telephone is answered2. Voltage of the Output Control Point Ignition Control: 0V Alarm Control: 12V Petrol Control : 0V Siren Control : 12V3. Input Checking Voltage Door: 0V Key: 12VFoot Brake: 12V 4. GSM Module Frequency Range: GSM 900MHZ/1800MHZ Voltage of Serial Interface: 2.8V Stand-by Current: 11-25mAControl Distance: No limit in the network of GSM 5. Remote Control Working Voltage: 12V(1 A27 12V dry battery) Working Frequency: 315MHz-316HMz Control Distance: >20M Static Current: 0mA 6. Working Conditions MainframeStorage Temp.: -30℃-85℃; Working Temp.: -20℃-65℃;Working Humidity: 25% — 95% AccessoryStorage Temp.: -40℃-100℃;Working Temp.: -20℃-85℃;Working Humidity: 25% — 95% Size of the Mainframe:134MM*120MM*34MM