Diamond Dermabrasion Microdermabrasion Beauty Equipment Beauty Machine

Operating Instruction for Diamond Dermabrasion

1. Push in the movable ring of copper nozzle at the hand piece, and pull out the 6x4 size vacuum hose. Then push in the black plastic ring on the vacuum hose.
2. Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the movable ring and insert in the vacuum hose to the limit.
3. Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment.
4. Turn on the power switch.
5. Adjust the Vacuum intensity by Vacuum Regulator according to the following reference table, the intensity displays on Vacuum gauge and check with the client for comfort.
Recommended Vacuum intensity on treatment area

Treatment Area  Normal Skin (inHg) Sensitive Skin (inHg)
Face 12-22 8-12
Forehead 12-22 10-12
Chest 15-20 15-18
Nose 10-15 10-14
Neck 18-18 10-15
Near Eye Area 8-12 8-10

Treatment Schedule Table

Treatment Frequency (days) Total Visits
Face Peeling 6-10 3-5
Fine Lines 7-13 6-8
Neck 12-14 3-5
Acne Scars 7-12 8-10
Hyperpigmentation 7-12 8-10

6 Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing so will cause harm to the skin.
7. Adjust the crystal flow rate by the Vacuum Regulator slowly from minimum to maximum. For commonly use, do not set the flow rate to maximum unless it is of necessity. This is for better
comfort intensity.
8. Gently stretch the skin with thumb and finger and glide the Hand-piece 2 to 3 times over the area being treated. Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites.

Functions:Removes skin debris, imperfections, blemishes, wrinkles and unwanted pigmentation on the skin.
Good choice for salon !