Liquid Molding Silicone Rubber

Liquid Molding Silicone Rubber has been used for more than 15 years to reproduce sculpture all over the world ranging in size from less than 1" (2.54 cm) to almost 400 feet high (120 m).

Today,  Liquid Molding Silicone Rubber are used by thousands of sculptors and foundries for casting wax, resins, plaster, concrete and other materials to make accurate reproductions of original sculpture.

Project Specific - Liquid Molding Silicone Rubber wide range includes mold rubbers that can be poured on , brushed on , sprayed on or pressed on to any original sculpture and will reproduce detail perfectly.

Liquid Molding Silicone Rubber features

Liquid Molding Silicone Rubber is a kind elastic silicon rubber mold which features as below:

• resistance to deformation,
• high-temperature resistance
• acid-alkali resistance
• expansion as well as high reproduction times,
• good tensile strength ,
• Strong Tear strength
• Good elongation
• Low shrinkage
• Long shelf time which can reach at least 1 year

 Storage and Precautions of Liquid Molding Silicone Rubber

High reproduction Liquid Molding Silicone Rubber, which is an environmentally-friendly liquid silicone product, is not easy to burn and can be stored and transported as non-hazardous goods. The shelf life of the product is about one year from the date of production. Inspection is required when exceeding the time limited. It can continue to be used in case of neither thickening nor deterioration.

OPERRATING INSTRUCTION of  Liquid Molding Silicone Rubber:

1. Stir part A and part B with right mixing ratio (1:1) evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

Please dont hesitate to ask if you have any questions about Liquid Molding Silicone Rubber, here Cassi is at your service:

Tel: 86-755-89948006

Cell:86-18938867521

Email: hyjg(at)szrl(dot)net