Potting silicone for LED

Potting silicone for LED

Potting silicone for LED Feature:
Potting silicone for LED for good elasticity is a kind of low viscosity, Inherent flame

resistance, two components addtion cured potting silicone with heat-conducting. It cures

with both on room temperature and heated temperature. It has the feature of the higher

temperature the faster of the curing time. It can be applied to electronic components for

insulation, waterproofing, fixed and flame retardant. It mainly applied in electronic

components surface with materials of  PC(Poly-carbonate),PP,ABS,PVC, etc. and metal

materials.

Potting silicone for LED resistance Application

HY 9055 could be applied to

- high powered electronics,

- DC/DC module and circuit board which requires heat dissipation and high temperature

resistance.

-It can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc.

Potting silicone for LED technical guidelines:

1, Pls put part A and part B in separate container and stir evenly before mixing the two

part together.

2, Mixing Ratio: part A: part B = 1:1

3, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes.Then the mixture

could be used for pouring.

4, Pls note that the thickness of the silicone affects the curing time. If the silicone used

is a little thick,then the curing time will be a little longer.The temperature also affects

the curing time.When in lower temperature, we suggest customers appropriately heat the

mixture to accelerate vulcanization. With temperature of 80~100°C, the silicone will cure

in 15 minutes; while in 25°C room temperature, the silicone will cure around 8 hours.

Potting silicone for LED Notes:
1.The following material may hinder the curing of HY 9055, So pls use after the test. When

necessary, pls clean the application areas.

Organotin compound or Condensation silicone with organotin

Sulphur, sulfide and sulfur rubber materials.

Amine compounds as well as contains the amine materials.

Pewters solder flux

2. HY 9055 should be sealed storage.The mixture should be used up disposably to avoid

causing waste.

3. HY 9055 belongs to non-dangerous goods, but keep away from mouth and eyes.

4. When it gets stratified after a period of storage, Please mix it evenly before

using,which does not affect the performance.

Potting silicone for LED Package :

20Kg/pail as a set (Part A 10Kg + Part B 10Kg)

Any questions, please feel free to contact Ms. Judy

MOBILE:086-18938867591

Skype: judy.zhao723