electronic Potting silicone rubber

                                                                         electronic Potting silicone rubber

Typical Application of electronic Potting silicone rubber

-----High powered electronics encapsulation

-----DC/DC module and circuit board which requires heat dissipation and high temperature resistance.

-----It can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc.

Product Feature of electronic Potting silicone rubber

Electronic potting compound is a kind of low viscosity, Inherent flame resistance, two components (1:1mixing ratio)addtion cured potting silicone with heat-conducting. It cures with both on room temperature and heated temperature. It has the feature of the higher temperature the faster of the curing time. It can be applied to electronic components for insulation, waterproofing, fixed and flame retardant. It mainly applied in electronic components surface with materials of PC(Poly-carbonate),PP,ABS,PVC, etc. and metal materials.

Notes and operation instructions of electronic Potting silicone rubber:

1).The following material may hinder the curing of electronic potting silicone, So pls use after the test. When necessary, pls clean the application areas.

lOrganotin compound or Condensation silicone with organotin

lSulphur, sulfide and sulfur rubber materials.

lAmine compounds as well as contains the amine materials.

lPewters solder flux

2). Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes.Then the mixture could be used for pouring.

3) Pls note that the thickness of the silicone affects the curing time. If the silicone used is a little thick,then the curing time will be a little longer.The temperature also affects the curing time.When in lower temperature, we suggest customers appropriately heat the mixture to accelerate vulcanization.

4) Above eclectronic potting silicone should be sealed storage.The mixture should be used up disposably to avoid causing waste.

5) Above silicone belongs to non-dangerous goods, but keep away from mouth and eyes.

6) When it gets stratified after a period of storage, Please mix it evenly before using,which does not affect the performance.

If you want to know some other more information about the electrical Potting compound silicone for PCB substrate , please don't hesitate to contact with Miss Caroline at any time :

Tel: +86-755-89948019

Mobile: +86-18938867567

Skype: cathy19900719

Email: hysf(at)szrl(dot)net

Website : www(dot)szrl(dot)net