polycondensation silicone rubber for mold making

Introduction of polycondensation silicone rubber for mold making:

1. The polycondensation silicone rubber is a flowable liquid silicon and curing agent.
2. The polycondensation silicone rubber can cures at room temperature within 4-6 hours.

FEATURES of polycondensation silicone rubber for mold making

resistance to deformation,

high-temperature resistance

acid-alkali resistance

expansion as well as high reproduction times,

good tensile strength ,

Strong Tear strength

Good elongation

Low shrinkage

Long shelf time which can reach at least 1 year

Datasheet of polycondensation silicone rubber for mold making

Operation guide of polycondensation silicone rubber for mold making

1. Stir part A and part B with right mixing ratio (100:5) evenly. And get the mixture for vacuum-pumping. (If there is no vacuum machine, just mix less catalyst)

2. Clean your products and brush a layer of release agent (detergent or soap water) on your product.

3. Pour the mixture with correct mixing ratio into the model frame.

After about 3-5 hours, when the silicone get cured, take out the original mold, and there is th finished silicone mould.

Any questions of Polycondensatin silicone rubber for mold making, please feel free to contact Ms Orianna:
TEL: 0086-755-89311348

FAX: 0086-755-89948030
MOBILE: 0086-18938867545

Skype: orianna317