Liquid Molding Silicone Rubber for Resin Garden Statue

Applications of Liquid Molding Silicone Rubber for Resin Garden Statue

Liquid Molding Silicone Rubber for Resin Garden Statue will reproduce the finest detail and is suitable for a variety of industrial and art related applications including prototypes, furniture, sculpture and architectural elements. mold making silicone rubber can also be used to cast a variety of materials including wax, gypsum, low melt alloys/metals and urethane, epoxy or polyester resins (without using a release agent).

Features of Liquid Molding Silicone Rubber for Resin Garden Statue

Good characteristics of easy-operation
Light viscosity and good flowability
Low shrinkage
Favorable tension
No deformation
Favorable hardness
High temperature resistance, acid and alkali-resistance and ageing resistance

Operation instructions for Liquid Molding Silicone Rubber for Resin Garden Statue

Step One: Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly.

Notes: Moulding silicon rubber is a kind of flowing liquid and it contains two parts. Part A is a kind of white flowing liquid and part B is the curing agent. Remember to mix part A and part B evenly, otherwise the silicon rubber will be partly solidified and this will give birth to difficulties in your final operation. What’s more, the finished moulds will meet a short life. All of these will cause a waste of silicon rubber.

Step Two: vacuum pumping

Without exception, this step takes less than 10 minutes. Otherwise, it will cause cross linking reaction, and no more further steps will be available.

Step Three: Brushing cast

Brushing cast:

a. Evenly brush the mixed silicon rubber on the product which is covered with mold spray with a brush or a brush pen.

b. After the cross linking reaction (about 30 minutes), brush a second coat which can increase the tension and tear strength of the mold.

c. Cover a glass cloth on it after another 30 minutes of a second cross linking reaction, and use a brush pen or a brush to avoid any interstices.

d. Cover a third coat.

(Note: if you have high requirements for the tension and the tear strength for the mold, please repeat step c and step d.Hence, the finished silicone moulds will have a good quality and a longer life, which can help you save cost and increase production efficiency.)

Any questions about Silicone Rubber, Leah is at your service.

TEL: 086-755-89212382

FAX: 086-755-89948030

MOBILE: 086-189 3886 7561

Website: www(dot)szrl(dot)net

E-MAIL: hyji(at)szrl(dot)net

Skype: leahchou1214

QQ: 189 3886 7561