200 - 40,000 kilogram
40,001 - 999,999 kilogram
group nameAddition cure silicone rubber
Min Order200 kilogram
brand nameHong Ye silicone rubber
modelHY-E635 silicone rubber
payment methodT/T, L/C, Westem Union
update timeFri, 08 Nov 2013 17:02:55 GMT
Color translucent
state liquid silicone rubber
Sample free slicone rubber
Mixing ratio 1:1
Shelf life 8-10 monthes
feature 1 high tensile strength
feature 2 high copy times
feature 3 in 42 shore A
feature 4 technical service available
feature 6 easy for operation
Min Order200 kilogram
Hot Deals !!! platinum cure silicone
Application of platinum cure silicone --
Platinum cured silicone is mainly used for making concrete stones, wax molds, PU molds,
resin molds, gypsum casting, candle molding and chocolate ,
candy and any other FDA food product mold making etc.
Features for E630 platinum cure silicone ----
Mixing ration 1:1 ---easy operation
Low viscosity , easy for pouring
shrinkgae : less than 1%
high tensile strength
FDA silicone
Here we list our E625 the parameter of platinum cure rtv silicone for your reference ---
Model | Color | Mixing ratio (%) | Pot life (mins) | Demould time ( hrs) | Hardness ( shore A ) | Tensile-strength (kgf/cm2 ) | Tear-strength (KN/m) | Viscosity after mixed (cps) | Shrinkage rate (%) | Elongation (%) |
E642 | Translucent | 1 : 1 | 30-40 | 6-8 | 42±2 | ~62 | ~15 | ~8000 | ≤0.1% | ~400% |
Operation instruction:
1.Pls clear the model and tool totally before operation to prevent cure inhibition.
2.Weigh the two part correctly by electronic weight in two separate container .
2. Mixing the two part in 1:1 and stir part A and part B evenly in 2-3 minutes .
3.And get the mixture for vacuum-pumping for de-air the bubble in around 2-3 minutes . (If there is no vacuum machine, pls pour the mixture carefully and slowly down the side of the mold frame so that less bubbles caused)
2. Enclose the product (the original model) with four plastic plates or wooden plates.
3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.
4. Pour the vacuumed mixture into the model frame from the side of the mold frame .
Notice : As our E-series silicone is platinum cure silicone , which is very easy to cause cure inhibition , so pls do remember thoroughly clean the model and tool before operation . Besides , pls avoid the liquid E-series silicone contact or mix with the following material , otherwise the silicone won’t be cured :
1.Liquid condensation silicone ( condensation silicone not completely cured or organic tin compounds )
2 .Sulphur, sulfide and sulfur rubber materials.
3. Amine compounds as well as contains the amine materials.
4 .Pewter solder flux.
More information , pls contactMs shirley
网络文化经营许可证:浙ICP备14006100号-11 2007-2024 Tradevv.com. All rights reserved.