Liquid Addition Cure Molding Silicone

Description of Liquid Addition Cure Molding Silicone

HY- E600# addition molding silicone is generally named two-component silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 1:1, mainly be suitable for making masks, arms, legs, and other FDA molds application.

Applications of Liquid Addition Cure Molding Silicone

HY- E600# addition molding silicone could be mainly used for making concrete stones, precision molds, PU molds, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

Technique Data of HY-E600# molding silicone

OPERRATING INSTRUCTION of HY-E600# molding silicone:

1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

SHELF LIFE: Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.

PACKAGE: Packed in clean 20kg/pail, 200kg/pail.

Any questions about Silicone Rubber, Leah is at your service.

TEL: 086-755-89212382

FAX: 086-755-89948030

MOBILE: 086-189 3886 7561

Website: www(dot)szrl(dot)net

E-MAIL: hyji(at)szrl(dot)net

Skype: leahchou1214

QQ: 189 3886 7561