How to make silicone mold for tyre

How to make silicone mold for tyre

Silicone Rubber For Tyre Molding  Characteristics

*low shrinkage (less than 0.1% )

*high tensile and tear strength with high copy times

*easy for operation (mixing ratio at 1:1 /10:1)

*very good flow and easy for pouring operation

*Fast and non-shrink cure at room temperature which can be accelerated considerably by the application of heat

Tyre Molding Silicone Rubber  Operation instruction

1. Pls clear the model and tool totally before operation to prevent cure inhibition.

2.Weigh the two part correctly by electronic weight in two separate container .

3. Mixing the two part in 1:1/10:1 and stir part A and part B evenly in 2-3 minutes .

4.And get the mixture for vacuum-pumping for de-air the bubble in around 2-3 minutes . (If there is no vacuum machine, pls pour the mixture carefully and slowly down the side of the mold frame so that less bubbles caused)

5. Enclose the product (the original model) with four plastic plates or wooden plates.

6. Clean your products and brush a layer of release agent(detergent or soap water) on

your product.

7. Pour the vacuumed mixture into the model frame from the side of the mold frame .

Silicone Rubber For Tyre Molding  Technical Parameters

(Please note: the above data for this product in 25°C temperature, 55percent humidity conditions, for reference. The accurate data is measured by customers when using.)

We are the leading manufacturer of liquid molding silicone rubber in China, we specialize in molding silicone rubber for tyre molding. tyre casting, moire inforamtion about how to make silicone mold for tyre   pls feel free to contact Ms Taylor:

Tel:086-755-89212380

Mob:086-18938867522

Skype: taylordl828