additional cure silicone rubber

                                                              Additional cure silicone rubber

Description of additional cure silicone rubber

additional silicone rubber  is generally named two-components silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 10:1,mainly be suitable for making FDA molds application.

Applications of additional cure silicone rubber

additional silicone rubber  could be mainly used for making concrete stones, precision molds, PU molds, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

Operation of additional cure silicone rubber

1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

Shelf life of additional cure silicone rubber

Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.

More information additional cure silicone rubber , please don't hesitate to contact with Miss Caroline at any time :

TEL: +86-755-89948019

Mobile: +86-18938867567

Skype: cathy19900719

Email: hysf(at)szrl(dot)net

Website : www(dot)szrl(dot)net