addition cured liquid Silicone rubber for injection molding

RTV-2 addition cured Liquid Silicone Rubber for Injection Molding is a two-component liquid silicone rubber for injection molding processes. HYE642 shows a higher productivity, less yellowing and low volatile contents. HYE642would be possible to increase productivity by reduce injection time and total cycle time. Also, it is easier to inject into the cavity of the mold which is more complicated designed. In addition, higher transparency and less volatile content make it most suitable for consumer products.

RTV-2 addition cured Liquid Silicone Rubber for Injection Molding Application:

Because of the outstanding properties,HYE642 is particularly suitable for the following elastomeric articles: sealing elements, O-rings, stoppers,diaphragms, keypads, bellows, vibration dampers, air vent flaps, switch covers, pressure cookers parts, cable connectors s.o.

RTV-2 addition cured Liquid Silicone Rubber for Injection Molding Specification:

Vulcanisates consisting of  HYE642 are distinguished by the following properties:

·High flowability, low viscosity and short injection time.

·Low volatiles content; Fast cure

·Excellent mold release, Excellent Thermal stability

·Excellent compression set; Excellent resilience

·High stability to ozone and ultraviolet light

·Outstanding resistance to ageing

·Not readily combustible, does not melt or drip

·Easy-pigmentable with LSR Colour Pastes fulfill the requirement of KTW

Processing Recommendations

Ready-to-use mixtures (of the components A and B) are fed directly to the injectionmoulding machine from the original containers by means of a metering and mixing unit. The mixture, consisting of the two components in the ratio 1:1, is injected into the heated mould. Because of low viscosity, the injection daospeed and injection pressure need to be carefully adjusted so that the injection time can be decreased. At mould temperatures of 170 - 230°C, the addition -crosslinking silicone rubber vulcanises free of dissociation products within a few seconds. Excellent flowability and easy demoulding permit fully automated production of large numbers of articles in shorter total cycle times.

SHELF LIFE:

8-10 months when stored under 24°C in original unopened packages.

PACKAGE:

Packed in 20kg/pail + 20kg/pail and 200kg/pail + 200kg/pail.

Any information of RTV-2 Liquid Silicone Rubber for Injection Molding , pls don't be hesitate to contact with Ms.Sarah 

Tel:0086-755-89948019 

Mob:0086-13620974715 

Fax:0086-755-89948030

E-mail: hysc(at)szrl(dot)net

Skype:sarah_szrl