liquid silicone potting material for electrical parts

silicone potting material for electronics   

silicone potting material for electronics Feature

 silicone potting material for electronics for good elasticity is a kind of low viscosity, Inherent flame resistance, two components 

silicone potting material for electronics with heat-conducting.

silicone potting material for electronics cures with both on room temperature and heated temperature.

silicone potting material for electronics has the feature of the higher temperature the faster of the curing time.

silicone potting material for electronics  can be applied to electronic components for insulation, waterproofing, fixed and flame retardant.

silicone potting material for electronics  is  mainly applied in electronic components surface with materials of  PC(Poly-carbonate),PP,ABS,PVC, etc. and metal materials.

silicone potting material for electronics Application

HY 9055 could be applied to

- High powered electronics, 

- DC/DC module and circuit board which requires heat dissipation and high temperature resistance.

-  silicone potting material for electronics can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc

silicone potting material for electronics   technical guidelines

1, Pls put part A and part B in separate container and stir evenly before mixing the two part together.

2, Mixing Ratio: part A: part B = 1:1

3, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes.Then the mixture could be used for pouring.

4, Pls note that the thickness of the silicone affects the curing time. If the silicone used is a little thick,then the curing time will be a little longer.The temperature also affects the curing time.When in lower temperature, we suggest customers appropriately heat the mixture to accelerate vulcanization. With temperature of 80~100°C, the silicone will cure in 15 minutes; while in 25°C room temperature, the silicone will cure around 8 hours.

silicone potting material for electronics   Notes
1.The following material may hinder the curing of HY 9055, So pls use after the test. When necessary, pls clean the application areas.

Organotin compound or Condensation silicone with organotin

Sulphur, sulfide and sulfur rubber materials.

Amine compounds as well as contains the amine materials.

Pewters solder flux

2. HY 9055 should be sealed storage.The mixture should be used up disposably to avoid causing waste.

3. HY 9055 belongs to non-dangerous goods, but keep away from mouth and eyes.

4. When it gets stratified after a period of storage, Please mix it evenly before using,which does not affect the performance.

silicone potting material for electronics   Package

20Kg/pail as a set (Part A 10Kg + Part B 10Kg)

 
Any questions abt silicone potting material for electronics please feel free to contact Ms Bella

Mobile: 0086-18938867572

Tel: 0086-755-89948006

Fax: 0086-755-89948030

Website: www (dot) szrl (dot) net

Email:hysi(at)szrl(dot)net

Skype: bellajiaqi

 Key Words: silicone potting material for electronics , silicone rubber,  LED Electronic Material rubber silicones ,  potting silicone compond for LED, Encapsulating compound silicone for LED,  silicone encapsulating for LED ,  RTV SILICONE, rubber silicone, silicone rubber manufacture, silicone rubber price