LED Electronic Material rubber silicones on sale

LED Electronic Material rubber silicones

LED Electronic Material rubber silicones  technical guidelines:

1, Pls put part A and part B in separate container and stir evenly before mixing the two part together.

2, Mixing Ratio: part A: part B = 1:1

3, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes. Then the mixture could be used for pouring.

4, Pls note that the thickness of the silicone affects the curing time. If the silicone used is a little thick, then the curing time will be a little longer. The temperature also affects the curing time. When in lower temperature, we suggest customers appropriately heat the mixture to accelerate vulcanization. With temperature of 80~100°C, the silicone will cure in 15 minutes; while in 25°C room temperature, the silicone will cure around 8 hours.

LED Electronic Material rubber silicones  Notes:
1.The following material may hinder the curing of HY 9055, So pls use after the test. When necessary, pls clean the application areas.

Organotin compound or Condensation silicone with organizing

Sulphur, sulfide and sulfur rubber materials.

Amine compounds as well as contains the amine materials.

Pewter’s solder flux

2. HY 9055 should be sealed storage. The mixture should be used up disposable to avoid causing waste.

3. HY 9055 belongs to non-dangerous goods, but keep away from mouth and eyes.

4. When it gets stratified after a period of storage, Please mix it evenly before using, which does not affect the performance.

LED Electronic Material rubber silicones  Package

20Kg/pail as a set (Part A 10Kg + Part B 10Kg)

Any more information abt  LED Electronic Material rubber silicones , pls feel free to contact Ms. Bella:

Mobile: 0086-18938867572

Tel: 0086-755-89948006 

Fax: 0086-755-89948030

Website: : www (dot) szrl (dot) net

Email:hysi(at)szrl(dot)net

Skype: bellajiaqi