Electronic Silicone Encapsulants for potting manufacturer

Electronic Silicone Encapsulants for potting Feature:
LED Silicone Rubber Electronic Material for good elasticity is a kind of low viscosity, Inherent flame resistance, two components addtion cured potting silicone with heat-conducting. It cures with both on room temperature and heated temperature. It has the feature of the higher temperature the faster of the curing time. It can be applied to electronic components for insulation, waterproofing, fixed and flame retardant. It mainly applied in electronic components surface with materials of  PC(Poly-carbonate),PP,ABS,PVC, etc. and metal materials.

Electronic Silicone Encapsulants for potting Application

HY 9055 could be applied to

- High powered electronics, 

- DC/DC module and circuit board which requires heat dissipation and high temperature resistance.

-It can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc.

Electronic Silicone Encapsulants for potting technical guidelines:

1, Pls put part A and part B in separate container and stir evenly before mixing the two part together.

2, Mixing Ratio: part A: part B = 1:1

3, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes.Then the mixture could be used for pouring.

4, Pls note that the thickness of the silicone affects the curing time. If the silicone used is a little thick,then the curing time will be a little longer.The temperature also affects the curing time.When in lower temperature, we suggest customers appropriately heat the mixture to accelerate vulcanization. With temperature of 80~100°C, the silicone will cure in 15 minutes; while in 25°C room temperature, the silicone will cure around 8 hours.

Any question about silicon rubber, Pls feel free to contact Christy

TEL: 086-755-89948006

FAX: 086-755-89948030

Mobile: 86-189 3886 7547

Skype: christyxu911

Email: hyxj(at)szrl(dot)net