FDA grade liquid silicone for dolls making

FDA grade liquid silicone for dolls making

FDA grade liquid silicone for dolls making Application

Y- Series addition molding silicone could be mainly used for making concrete

Stones, wax molds, PU molds, resin molds, gypsum casting, candle molding and

chocolate, candy and any other FDA food product mold making, prototyping etc.

Y-series Silicone Rubber has been used to life casting applications for years.

Specifications of FDA grade liquid silicone for dolls making

*low shrinkage (less than 0.1% )

*high tensile and tear strength with high copy times

*easy for operation (mixing ratio at 1:1 /10:1)

*very good flow and easy for pouring operation

*Fast and non-shrink cure at room temperature which can be accelerated considerably by the application of heat

Features of FDA grade liquid silicone for dolls making

FDA grade liquid silicone for dolls making is white or red flowing liquid with general hardness of 22-50A°after curing. Molding silicon rubber is a kind elastic silicon rubber mold which features with resistance to deformation, high-temperature, acid-alkali and expansion as well as high reproduction times, good tensile strength, tear strength and elongation.

Technical Parameters of FDA grade liquid silicone for dolls making

(Please note: the above data for this product in 25°C temperature, 55percent humidity conditions, for reference. The accurate data is measured by customers when using.)

Operation instruction of Y- Series molding silicone:

1. Pls clear the model and tool totally before operation to prevent cure inhibition.

2.Weigh the two part correctly by electronic weight in two separate container .

3. Mixing the two part in 1:1/10:1 and stir part A and part B evenly in 2-3 minutes .

4.And get the mixture for vacuum-pumping for de-air the bubble in around 2-3

minutes . (If there is no vacuum machine, pls pour the mixture carefully and slowly

down the side of the mold frame so that less bubbles caused)

5. Enclose the product (the original model) with four plastic plates or wooden plates.

6. Clean your products and brush a layer of release agent(detergent or soap water) on

your product.

7. Pour the vacuumed mixture into the model frame from the side of the mold frame .

Any more information abt FDA grade liquid silicone for dolls making , pls feel free to contact Ms. Bella:

Mobile: 0086-18938867572 

Tel: 0086-755-89948006

 Fax: 0086-755-89948030

 Website: www (dot) szrl (dot) net

 Email:hysi(at)szrl(dot)net

Skype: bellajiaqi