Liquid injection moulding silicone (rubber) for (making) baby nipples

                     Liquid injection moulding silicone rubber for making baby nipples

Liquid injection moulding silicone rubber for baby nipples  is a two-component liquid silicone rubber for injection molding processes. HY-923 shows a higher productivity, less yellowing and low volatile contents. HY-923 would be possible to increase productivity by reduce injection time and total cycle time. Also, it is easier to inject into the cavity of the mold which is more complicated designed. In addition, higher transparency and less volatile content make it most suitable for consumer products.

Application of Liquid injection moulding silicone rubber for making baby nipples:

Because of the outstanding properties,HY-923 is particularly suitable for the following elastomeric articles:  baby nipples . sealing elements, O-rings, stoppers,diaphragms, keypads, bellows, vibration dampers, air vent flaps, switch covers, pressure cookers parts, cable connectors s.o.

Specification of Liquid injection moulding silicone rubber for making baby nipples:

Vulcanisates consisting of HY-923 are distinguished by the following properties:

·High flowability, low viscosity and short injection time.

·Low volatiles content; Fast cure

·Excellent mold release, Excellent Thermal stability

·Excellent compression set; Excellent resilience

·High stability to ozone and ultraviolet light

·Outstanding resistance to ageing

·Not readily combustible, does not melt or drip

·Easy-pigmentable with LSR Colour Pastes fulfill the requirement of KTW

Typical Physical Properties of Liquid injection moulding silicone rubber for making baby nipples:

Processing Recommendations of Liquid injection moulding silicone rubber for making baby nipples

Ready-to-use mixtures (of the components A and B) are fed directly to the injectionmoulding machine from the original containers by means of a metering and mixing unit. The mixture, consisting of the two components in the ratio 1:1, is injected into the heated mould. Because of low viscosity, the injection daospeed and injection pressure need to be carefully adjusted so that the injection time can be decreased. At mould temperatures of 170 - 230°C, the addition -crosslinking silicone rubber vulcanises free of dissociation products within a few seconds. Excellent flowability and easy demoulding permit fully automated production of large numbers of articles in shorter total cycle times.

SHELF LIFE of Liquid injection moulding silicone rubber for making baby nipples:

8-10 months when stored under 24°C in original unopened packages.

PACKAGE of Liquid injection moulding silicone rubber for making baby nipples:

Packed in 20kg/pail + 20kg/pail and 200kg/pail + 200kg/pail.

If you need any more information about the liquid injection moulding silicone  for (Making) baby nipples  , pls don't hesitate to contact with Miss Caroline at any time:

TEL: +86-755-89948019

Mobile: +86-18938867567

Skype: cathy19900719

Email: hysf(at)szrl(dot)net

Website : www(dot)szrl(dot)net