liquid Silicone material for making insole

1.  Silicone material for making insole Introduction:  

HY- E620# addition molding silicone is generally named two-components silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 1:1,mainly be suitable for making  masks, arms, legs, and other FDA molds application.

2. Silicone material for making insole Application:

HY- E620# addition molding silicone could be mainly used for making silicone insoles, concrete stones, precision molds, PU molds, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

3.Technique Data of Silicone material for making insole: 

4.OPERRATING INSTRUCTION of Silicone material for making insole mold :

1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

SHELF LIFE: Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.

Any more information abt Silicone material for making insole mold, pls feel free to contact Ms.Bella

Mobile:0086-18938867572

Tel: 0086-755-892948006

Fax: 0086-755-89948030

Website: www (dot) szrl (dot) net

Email:hysi(at)szrl(dot)net

Skype: bellajiaqi