two part silicone rubber

Introduction of two part silicone rubber

Two part silicone rubber is a kind of liquid fluid, features good fluidity and good operation., large duplication times

Features of two part silicone rubber:

1). Good characteristics of easy-operation

2). Ligh viscosity and good flowability

3). Low shrinkage

4). Favorable tension

5). No deformation

Operations of two part silicone rubber:

Step One: Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly.

Step Two: vacuum pumping

Without exception, this step takes less than 10 minutes. Otherwise, it will cause , and no more further steps will be available 

Step Three: Perfusion Molding of two part silicone rubber

The perfusion molding is an easy way to make molds, it’s Slowly and evenly perfuse the mixed silicon rubber into the square frame. After the cross linking reaction.

Why isn’t the two part silicone rubber mold acid & alkali and aging resistant?

It is due to the addition of the silicon oil. Normally we do not advise our customers to add any silicon oil into the silicon rubber. If it is necessary, the ratio must be 5%-10%.

For getting further information about two part silicone rubber, PLS contact with Miss Caroline

Tel: +86-755-89948019

Mobile: +86-18938867567

Skype: cathy19900719

Email: hysf(at)szrl(dot)net

Website : www(dot)szrl(dot)net