Manual silicone rubber for electronics

Introduction of the manual mold silicone rubber for electronics:

manual mold silicon rubber for electronics is mainly applicable to manual molds and small number of product duplication

Features of the manual mold silicone rubber  for electronics:

Manual mold silicone has good elasticity, non-deformation , high temperature resistance, low shrinkage. And it is suitable for manual mold design and small duplication mold production.

Mold of the Manual silicone rubber for electronics:

528#  540#  570#

FAQ:What should you do for deformation of the silicone mold ?

It should deal apart according to the size of the products, In principle, the hardness of the silicone should be according to the size of the products. If the products features small size and detailed patterns on it, the soft silicone can be applicable which the shore A should be 15-20 for easy demoulding and not damage of the patterns. Other wise harder silicone should be needed for large size products, such as products with size 50cm will need harder silicone with 40-50 shore A , then no-deformation. If Large products but features detailed patterns then 30 shore A silicone will be workable.(The process should be a layer silicone add a layer fiber glass or cloth..).The outer of mold can be plaster, glass fiber reinforced plastic(unsaturated resin and fiber glass) to protect the products from deformation.

For getting further  information about  manual mold  silicone  for electronics,  PLS contact with Miss Caroline

TEL: +86-755-89948019

Mobile: +86-18938867567

Skype: cathy19900719

Email: hysf(at)szrl(dot)net

Website : www(dot)szrl(dot)net