Manual silicone for reproduction of cultural relic

1.Features of the manual mold for reproduction of cultural relic:

Manual silicone for reproduction of cultural relic has good elasticity, non-deformation , high temperature resistance, low shrinkage. And it is suitable for manual mold design and small duplication mold production.

2.Introduction of the Manual silicone for reproduction of cultural relic:

Manual silicone for reproduction of cultural relic is mainly applicable to manual molds and small number of product duplication

3.Mold of the Manual silicone for reproduction of cultural relic:

528#  540#  570#

4.Profile of Manual silicone for reproduction of cultural relic:

HY-528# is applicable to make molds of smaller products and the production will be 2-3 pieces.

HY-540# , compared to other two types, for its moderate hardness and better quality & performance, its production will be 20-30 pieces.

HY-570# is applicable to large size products duplications and  Electronic equipment antivibration.

5.Operation Instruction for Manual silicone for reproduction of cultural relic:

(1)  Correct mixing ratio

Component A is silicone rubber, and component B is curing agent or vulcanizing agent, usually the mixing ratio  will be 2-3%. Such as to 100G silicone rubber should be added 2G catalyst and then mix them totally 

(2) Preparation of the Original molds

Firstly, you should deal carefully with the Original mold or the products you want to be molded.  

(3)Vacuum-Pumping Process

To mix the silicone and catalyst with a standard mixing ratio and then do the process of Vacuum-Pumping. Bubbles will come out during the mixing of the silicone and hardener

6.For getting further  information about  manual mold  silicone  for reproduction of cultural relic,  PLS contact with Miss Caroline:

TEL: +86-755-89948019

Mobile: +86-18938867567

Skype: cathy19900719

Email: hysf(at)szrl(dot)net

Website : www(dot)szrl(dot)net