Platinum Addition Cure Silicone Rubber for mould making

Platinum Addition Cure  Silicone Rubber for mould making

Description

HY- E615# addition molding silicone is generally named two-components silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 1:1,mainly be suitable for making  masks, arms, legs, and other FDA molds application.

Applications of platinum addition cure silicone rubber,

HY- E615# addition molding silicone could be mainly used for making concrete stones, precision molds, PU molds, cake molds,for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

Technique Data of HY-E615# of platinum addition cure silicone rubber

OPERRATING INSTRUCTION of HY-E615# : of platinum addition cure silicone rubber

1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)

 2. Enclose the product (the original model) with four plastic plates or wooden plates.

 3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

 4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold . 

 SHELF LIFE: Twelve (12) months from date of shipment when stored at 24°Cin original unopened packages.

Any questions of silicone rubber for mold making, please feel free to contact sarah:

TEL: 086-755-89948019

FAX: 086-755-89948030

MOBILE:086-13620974715

E-MAIL: hysc(at)szrl(dot)net

Website: www(dot)szrl(dot)net