RTV silicone rubber for solid tire molds, your best choice

                 WELCOME TO HONG YE SILICONE                         

                                                                   We'll do my best to help you save cost !!!

RTV silicone rubber for solid  tire  molds, your best choice

1)Characteristics of RTV silicone rubber for solid  tire  molds

*low shrinkage (less than 0.1% )

*high tensile and tear strength with high copy times

*easy for operation (mixing ratio at 1:1 /10:1)

*very good flow and easy for pouring operation

*Fast and non-shrink cure at room temperature which can be accelerated considerably by the application of heat

2)Description of RTV silicone rubber for solid  tire  molds

HY- E series addition molding silicone is generally named two-components silicone

rubber, Part A and part B. It features an exceptional fluidity and good operability.

The mixing ratio is 1:1 (10:1),mainly be suitable for making molds application.

3)Typical Applications of RTV silicone rubber for solid  tire  molds

HY- E series addition molding silicone could be mainly used for making concrete

stones, wax molds, PU molds, resin molds, gypsum casting, candle molding and

chocolate , candy and any other FDA food product mold making,prototyping etc.

HY-E620 Silicone Rubberis has been used for years to make tire pattern molds.

4)Technical ParametersRTV silicone rubber for solid  tire  molds 

(Please note: the above data for this product in 25°C temperature, 55percent humidity conditions, for reference.

The accurate data is measured by customers when using.)

5)Operation instruction of RTV silicone rubber for solid  tire  molds 

1. Pls clear the model and tool totally before operation to prevent cure inhibition.

2.Weigh the two part correctly by electronic weight in two separate container .

3. Mixing the two part in 1:1/10:1 and stir part A and part B evenly in 2-3 minutes .

4.And get the mixture for vacuum-pumping for de-air the bubble in around 2-3

minutes . (If there is no vacuum machine, pls pour the mixture carefully and slowly

down the side of the mold frame so that less bubbles caused)

5. Enclose the product (the original model) with four plastic plates or wooden plates.

6. Clean your products and brush a layer of release agent(detergent or soap water) on

your product.

7. Pour the vacuumed mixture into the model frame from the side of the mold frame .

Notice of  RTV silicone rubber for solid  tire  molds

As our E-series silicone is platinum cure silicone , which is very easy to cause

cure inhibition , so pls do remember thoroughly clean the model and tool before

operation . Besides , pls avoid the liquid E-series silicone contact or mix with the

following material , otherwise the silicone won’t be cured :

1. Liquid condensation silicone ( condensation silicone not completely cured or organic

tin compounds )

2 .Sulphur, sulfide and sulfur rubber materials.

3. Amine compounds as well as contains the amine materials.

4 .Pewter solder flux. 

Pic of tyre mold liquid silicone rubber

8-10 months when stored under 24°C in original unopened packages.

   Any questions of  adult toys rtv silicone rubber ,please feel free to contact Cindy (sales supervisor) :

Tel: 86-755-89948158

Mob: 86-13266634823

Email:hysg(at)szrl(dot)net

Skype:cindyyeah5